Browse By Category

Heidenhain ST 1207 Specto Length Gauges provide 11uApp output, extended by pneumatic (air) push and available in a right or straight cable exit. Specto length gauges are equipped with a ball-bush guide.

 

Some of the basic properties of ball-bush guides are:

 

  • Low friction, which makes versions of length gauges with reduce d gauging force possible
  • Safe plunger extension and retraction even with high radial force
  • High precision of the measuring loop thanks to a guide that is free of play (the bearing and plunger are specifically fitted during manufacturing)

 

Pneumatic Plunger Actuation: The Heidenhain ST 1207 gauge is extended by the application of compressed air. When the air is ventilated out the plunger retracts back to its protected resting position. The gauging force can be adjusted as needed through the level of air pressure used.

 

  • The operating orientation (-0.07 N, +0.07 N)
  • The plunger position (can be adjusted through the air pressure level)
  • The direction of the measurement (whether extension or retraction of the plunger is used)

 

An 8h6 diameter clamping shank comes standard with ST length gauges. Therefore these Heidenhain length gauges can easily be used with existing measuring fixtures and standards. Heidenhain offers the choice of a special clamping sleeve or a clamping bush each containing one screw. The accessories make it easier to fasten the length gauge without overloading the 8h6 clamping shank or damaging the ball-bush guide. The clamping bush also enables a wide tolerance field for tightening toque and improves fastening.

 

Clamping Sleeve ID: 386811-01

 

Clamping Bush ID: 1177968-02

 

The plungers of the Heidenhain ST 1207 Specto length gauges are protected by a rubber bellows. The bellows has high resistance to chemical and thermal influences, and have relatively no stiffness. There is little to no influence on the gauges mechanical behavior and measuring force.

 

Thermal Characteristics: Heidenhain length gauges have a defined thermal behavior. While temperature variations during measuring can result in changes to the measuring loop; Heidenhain uses special material with low coefficients of expansion for the components of the measuring loop.

 

Repeatability: In some instances the repeatability of the measurement is more important than the accuracy over the entire measuring range. It plays a very important role in the repeated measurement of the product. The repeatability of the length gauge is typically better than the values listed by Heidenhain.  

 

Repeatability depends on: combinations of materials used in the components, installed electronics, optomechanics  used, and the bearing of the plunger. Typically the ST 1207 has a repeatability pf 0.25 um.

Heidenhain 386912-01 (ST 1207) Specto 12mm Right Angle Digital Probe w/1.0um Accuracy, Extended by Compressed Air and 11 uApp Output

 

  • Travel: 12mm
  • Cable Outlet: Right Angle
  • Plunger actuation: extended with compressed air
  • Type of guide: ball guide
  • Reference mark: 5mm
  • Output: 11 uApp
  • Accuracy: 1.0um
  • Electrical connection: Connector M23, 9-pin male
  • Protection: IP64
  • Grating period: 20.0um
  • Power supply: 5V ± 10%
  • Cable Length: 1.5 meters

Looking for a Reliable & Stable Partner?

CONTACT US today
MDNA AMEA
Get a quote

Walker Machinery is proud to have partnered with some of the leading manufacturers of industrial clutches and brakes to deliver you the most advanced motion control solutions available on today’s market.

Quote Request

If you have any questions regarding the products we are offering, pleasee fill out the form below and one of our representavies will contact your shortly. Thank you for your interest in Walker Machinery!